Datasheet LT8391 (Linear Technology) - 5

HerstellerLinear Technology
Beschreibung60V Synchronous 4-Switch Buck-Boost LED Controller with Spread Spectrum
Seiten / Seite34 / 5 — The. denotes the specifications which apply over the full operating
RevisionA
Dateiformat / GrößePDF / 466 Kb
DokumentenspracheEnglisch

The. denotes the specifications which apply over the full operating

The denotes the specifications which apply over the full operating

Modelllinie für dieses Datenblatt

Textversion des Dokuments

LT8391 ELECTRICAL CHARACTERISTICS
The
l
denotes the specifications which apply over the full operating temperature range, otherwise specifications are at TA = 25°C. (Note 2). VIN = 12V, VEN/UVLO = 1.5V unless otherwise noted. SYMBOL PARAMETER CONDITIONS MIN TYP MAX UNITS Current Comparator
Maximum Current Sense Threshold V(LSP-LSN) Buck, VFB = 0.8V l 35 50 65 mV Boost, VFB = 0.8V l 40 50 60 mV Reverse Current Sense Threshold V(LSP-LSN) Buck, VFB = 0.8V –4 mV Boost, VFB = 0.8V –4 mV LSP Pin Bias Current VLSP = VLSN = 12V 60 µA LSN Pin Bias Current VLSP = VLSN = 12V 60 µA
Fault
FB Overvoltage Threshold (VFB) Rising l 1.03 1.05 1.07 V FB Overvoltage Hysteresis l 15 25 35 mV FB Open LED Threshold (VFB) Rising, V(ISP-ISN) = 0V l 0.93 0.95 0.97 V FB Open LED Hysteresis V(ISP-ISN) = 0V l 35 50 65 mV FB Short LED Threshold (VFB) Falling l 0.24 0.25 0.26 V FB Short LED Hysteresis Hysteresis l 35 50 65 mV ISP/ISN Over Current Threshold V(ISP-ISN) VISP = 12V 750 mV ISP/ISN Open LED Threshold V(ISP-ISN) Falling, VFB = 1.0V l 8 10 12 mV ISP/ISN Open LED Hysteresis VFB = 1.0V l 3 5 7 mV FAULT Pull-Down Resistance 100 200 Ω SS Hard Pull-Down Resistance VEN/UVLO = 1.1V 100 200 Ω SS Pull-Up Current VFB = 0.8V, VSS = 0V 10.5 12.5 14.5 µA SS Pull-Down Current VFB = 1.0V, VSS = 2V 1.05 1.25 1.45 µA SS Fault Latch-Off Threshold Falling 1.7 V SS Fault Latch-Off Hysteresis 50 mV SS Fault Reset Threshold 0.2 V
Oscillator
RT Pin Voltage RT = 100kΩ 1.00 V Switching Frequency VSYNC/SPRD = 0V, RT = 226k l 190 200 210 kHz VSYNC/SPRD = 0V, RT = 100k l 380 400 420 kHz VSYNC/SPRD = 0V, RT = 59.0k l 570 600 630 kHz SYNC Frequency 150 650 kHz SYNC/SPRD Input Bias Current VSYNC/SPRD = 5V –0.1 0 0.1 µA SYNC/SPRD Threshold Voltage 0.4 1.5 V Highest Spread Spectrum Above Oscillator VSYNC/SPRD = 5V 12.5 14.5 16.5 % Frequency Lowest Spread Spectrum Below Oscillator VSYNC/SPRD = 5V –17.7 –15.7 –13.7 % Frequency 8391fa For more information www.linear.com/LT8391 5