Datasheet LT3595A (Analog Devices) - 10

HerstellerAnalog Devices
Beschreibung16 Channel Buck Mode LED Driver
Seiten / Seite16 / 10 — APPLICATIONS INFORMATION. Open LED Detection. Table 2. Recommended Output …
Dateiformat / GrößePDF / 392 Kb
DokumentenspracheEnglisch

APPLICATIONS INFORMATION. Open LED Detection. Table 2. Recommended Output Capacitor Values (VLED = 3.5V). # LEDs. COUT (μF)

APPLICATIONS INFORMATION Open LED Detection Table 2 Recommended Output Capacitor Values (VLED = 3.5V) # LEDs COUT (μF)

Modelllinie für dieses Datenblatt

Textversion des Dokuments

LT3595A
APPLICATIONS INFORMATION
string depends on the number of LEDs and can vary from
Open LED Detection
0.47μF to 1μF. Refer to Table 2 for proper output capacitor The LT3595A detects an open LED on any channel and selection. reports it to the OPENLED pin. The fault also reports dur-
Table 2. Recommended Output Capacitor Values (VLED = 3.5V)
ing startup until the output voltage and LED current are
# LEDs COUT (μF)
in regulation. Therefore, it can also be used as a “power 3-10 0.47 ok” signal. 1-2 1
Programming LED Current Table 3. Recommended Ceramic Capacitor Manufacturers
The set resistor (RSET in the Block Diagram) controls Taiyo Yuden 408-573-4150 the LED current in all sixteen channels. LED current as www.t-yuden.com a function of the RSET resistance is shown in the Typical TDK 847-803-6100 Performance Characteristics. Common values for LED cur- www.component.tdk.com rent and their required resistor values are listed in Table 4. Murata 770-436-1300 Since resistor error directly translates to LED current error, www.murata.com precision resistors are preferred (1% is recommended). Kemet 800-533-1992 www.kemet.com The maximum allowed resistor value is 150k. Table 3 shows a list of several ceramic capacitor manufac-
Table 4. LED Current vs RSET Resistance
turers. Consult the manufacturers for detailed information
RSET (k
Ω
) ILED (mA)
on their entire selection of ceramic parts. 150 10 75.0 20 49.9 30 37.4 40 30.1 50 3595af 10