Datasheet Microchip MCP25612FD-H/SL — Datenblatt

MCP25612FD
Dual CAN Flexible Data-Rate Transceiver
Features Supports both “classic” CAN 2.0 and CAN FD
physical layer requirements Optimized for CAN FD (Flexible Data-Rate) at
2, 5 and 8 Mbps Operation:
-Maximum Propagation Delay: 120 ns
-Loop Delay Symmetry: -10%/+10% (2 Mbps) Implements ISO-11898-2 and ISO-11898-5
Standard Physical Layer Requirements Very Low Standby Current (5 ВµA per transceiver,
typical) Two Fully Independent VDDX and VSSX Pins per CAN
FD Transceiver for Added Flexibility and Reliability:
-Optimal for redundant CAN networks Compatible to 5V MCUs Functional Behavior Predictable Under All Supply
Conditions:
-Device is in Unpowered mode if VDDX drops
below undervoltage level
-An unpowered node or brown-out event will
not load the CAN bus Detection of Ground Fault:
-Permanent dominant detection on TXDX
-Permanent dominant detection on bus Power-on Reset and Undervoltage Lock-out on
VDDX Pin Protection against Damage due to Short-Circuit
Conditions (positive or negative battery voltage) Protection against High-Voltage Transients in
Automotive Environments Automatic Thermal Shutdown Protection Suitable for 12V and 24V Systems Meets or exceeds Stringent Automotive Design
Requirements, including “Hardware Requirements
for LIN, CAN and FlexRayв„ў Interfaces in …