Datasheet Texas Instruments CC1201 — Datenblatt

Hersteller	Texas Instruments
Serie	CC1201

Datenblätter

Preise

Status

Verpackung

Parameter

Parameters / Models	CC1201RHBR	CC1201RHBT
Data Rate(Max), kbps	1250	1250
Device Type	Smart RF Transceiver	Smart RF Transceiver
Frequency Bands, MHz	169,433,470,868,915,920	169,433,470,868,915,920
Operating Temperature Range, C	-40 to 85	-40 to 85
RX Current (Lowest), mA	19	19
Rating	Catalog	Catalog
Sensitivity (Best), dBm	-120	-120
Special Features	N/A	N/A
TX Power(Max), dBm	16	16
Technology	Sub-1 GHz	Sub-1 GHz
Throughput(Max), Mbps	1.25	1.25

Öko-Plan

Anwendungshinweise

• Herunterladen
  AN126 - Using the CC1200 Under ARIB STD T108
  PDF, 3.1 Mb, Datei veröffentlicht: Mar 11, 2014
  This application report outlines the expected performance when operating CC1200 under ARIB T108 in the 920 MHz frequency band. It is assumed that you are familiar with CC1200 and ARIB T108 regulatory limits. Lab measurements show that CC1200 meets ARIB T108 requirements.
• Herunterladen
  AN125 - CC2538 + CC1200 Evaluation Module
  PDF, 1.3 Mb, Datei veröffentlicht: Sep 5, 2013
  This application report describes how to combine the CC2538 and the CC1200 devices in the same design. It further describes the expected performance from this combination as well as important factors to consider with respect to the layout. It describes how to interface the CC2538+CC1200 combo evaluation module (EM) with the SmartRF06 EB and the CC Debugger to individually test and analyze the perf
• Herunterladen
  CC112x/CC120x RX Sniff Mode (Rev. A)
  PDF, 836 Kb, Revision: A, Datei veröffentlicht: Oct 9, 2013
  This application report shows how the RX Sniff Mode can be configured for different TX configurations and discusses how average power consumption can be estimated for a receiver implementing this mode. You are expected to have basic knowledge on how the enhanced Wake on Radio (eWOR) and the RX Sniff Mode are implemented in TI's Performance Line Sub-1 GHz RF family of devices.
• Herunterladen
  DN403 -- CC112x/CC120x On-Chip Temperature Sensor (Rev. C)
  PDF, 161 Kb, Revision: C, Datei veröffentlicht: Jun 26, 2014
  This application report provides the necessary information to use the temperature sensor of the CC112X and CC120X families. The temperature sensor is based on a proportional to absolute temperature (PTAT) current from a bandgap cell fed to a resistor to generate a PTAT voltage. It is possible to read out the temperature information either as an analog voltage on a general-purpose input/output (GPI
• Herunterladen
  CC112X/CC120X On-Chip Battery Monitor
  PDF, 57 Kb, Datei veröffentlicht: Dec 3, 2014
  This application report provides the necessary information in order to use the voltage sensor of the CC112x and CC120x family. The voltage sensor can be used to monitor the supply and battery voltage (VDD).
• Herunterladen
  CC112x/CC120x RX Sniff mode with Smart Preamble
  PDF, 278 Kb, Datei veröffentlicht: Oct 23, 2013
  This application report shows an innovative way to use the DualSync functionality of the CC112x/CC120x to handle a new kind of preamble. By using what is called SmartPreamble, the receiver is able to reliably detect exactly where it woke up in the preamble and use the eWOR timer to go back to sleep, and then wake up right before the sync word.
• Herunterladen
  AN121 – Wireless M-Bus Implementation with CC112x/CC120x High Performance Transc
  PDF, 2.8 Mb, Datei veröffentlicht: Feb 20, 2013
• Herunterladen
  AN112 -- Using CC1190 Front End With CC112x/CC120x Under EN 300 220 (Rev. C)
  PDF, 606 Kb, Revision: C, Datei veröffentlicht: Jun 21, 2013
  This application report outlines the expected performance when using a CC1120-CC1190 design underEN 300 220-1 V2.3.1 in the 869.4-869.65 MHz frequency sub-band (g3). The maximum allowed outputpower in the 869.4-869.65 MHz sub-band is +27 dBm (500 mW).For details on the regulatory limits in the 863-870 MHz SRD frequency bands, see the ETSI EN 300 220-1V2.3.1 and ERC recommendation 70-0
• Herunterladen
  CC1120-CC1190 BoosterPack
  PDF, 3.0 Mb, Datei veröffentlicht: Oct 5, 2015
  As the module is designed to support both Launchpadв„ў and SmartRFв„ў Studio platforms, configure the board by changing the on-board jumper positions according to your application. The default configuration of the jumpers on the BoosterPackв„ў module is set for LaunchPad applications. The interface details of CC112x-CC1190 BoosterPack with LaunchPad and SmartRF Studio applications are
• Herunterladen
  DN039 -- IPC for 868/915 MHz operation with the CC112x, CC117x and CC12xx
  PDF, 406 Kb, Datei veröffentlicht: Aug 20, 2012
  CC1120, CC1121, CC1125, CC1175 DN039 -- Matched Integrated Passive Component for 868 / 915 MHz Operation With CC112x, PDF Source
• Herunterladen
  DN040 -- Reduced Battery Current Using CC112x, CC1175_and CC1200 with TPS62730
  PDF, 454 Kb, Datei veröffentlicht: Oct 2, 2012
• Herunterladen
  AN110 – Using CC1190 Front End with CC112x/CC120x under FCC 15.247 (Rev. B)
  PDF, 555 Kb, Revision: B, Datei veröffentlicht: Jun 13, 2013
• Herunterladen
  DN038 -- Miniature Helical PCB Antenna for 868 MHz or 915/920 MHz
  PDF, 905 Kb, Datei veröffentlicht: Nov 27, 2012
  CC1120, CC1121, CC1125, CC1175, CC1200, CC1201, CC1111, CC1101, CC1110, CC110L Miniature Helical PCB Antenna for 868 MHz or 915/920 MHz CC113L, CC115L
• Herunterladen
  Antenna Diversity
  PDF, 556 Kb, Datei veröffentlicht: Oct 23, 2014
  This application report provides real-world measurement results showing the benefit of antenna diversity. The CC1200 radio transceiver is used as an example in this design note, but the results are applicable for all TI LPRF radios.
• Herunterladen
  Achieving Optimum Radio Range (Rev. A)
  PDF, 8.7 Mb, Revision: A, Datei veröffentlicht: Sep 5, 2017
  This application report addresses the parameters that affect the radio range. For identical radio settings, the range is highly dependent on the surroundings and environment. The link budget and the positioning of the antennas and their distance to the ground surface are major contributors to long range. A general specific range can never be specified or guaranteed for any type of radio communicat
• Herunterladen
  CC-Antenna-DK2 and Antenna Measurements Summary
  PDF, 14.8 Mb, Datei veröffentlicht: Mar 3, 2016
  The purpose of the antenna development kit (CC-Antenna-DK2) is to ease the decision of which type of low-cost antenna can be implemented as well as give an estimation of the performance that can be achieved.
• Herunterladen
  DN035 -- Antenna Quick Guide (Rev. A)
  PDF, 138 Kb, Revision: A, Datei veröffentlicht: Feb 12, 2013

Modellreihe

Herstellerklassifikation

• Semiconductors> Wireless Connectivity> Companion Wireless Solutions> Smart RF Transceivers