Datasheet Texas Instruments UCC2817APW — Datenblatt
Hersteller | Texas Instruments |
Serie | UCC2817A |
Artikelnummer | UCC2817APW |
BiCMOS Power Factor Preregualtor 16-TSSOP -40 bis 85
Datenblätter
UCCx81xA BiCMOS Power Factor Preregulator datasheet
PDF, 1.1 Mb, Revision: D, Datei veröffentlicht: Aug 31, 2016
Auszug aus dem Dokument
Preise
Status
Lifecycle Status | Active (Recommended for new designs) |
Manufacture's Sample Availability | Yes |
Verpackung
Pin | 16 |
Package Type | PW |
Industry STD Term | TSSOP |
JEDEC Code | R-PDSO-G |
Package QTY | 90 |
Carrier | TUBE |
Device Marking | 2817A |
Width (mm) | 4.4 |
Length (mm) | 5 |
Thickness (mm) | 1 |
Pitch (mm) | .65 |
Max Height (mm) | 1.2 |
Mechanical Data | Herunterladen |
Parameter
Control Method | CCM |
Device Type | Single-phase PFC |
Operating Supply Current | 4 mA |
Operating Supply(Max) | 18 V |
Operating Temperature Range | -40 to 85 C |
Package Group | TSSOP |
Package Size: mm2:W x L | 16TSSOP: 32 mm2: 6.4 x 5(TSSOP) PKG |
Peak Output Sink Current Gate Drive | 1.2 A |
Peak Output Source Current Gate Drive | -1.2 A |
Practical Operating Frequency(Max) | 0.25 MHz |
Rating | Catalog |
Special Features | > 750W Applications,Average Current Mode,Enable,OVP |
Startup Current | 0.15 mA |
UVLO Thresholds On/Off | 16/10 V |
Öko-Plan
RoHS | Compliant |
Design Kits und Evaluierungsmodule
- Evaluation Modules & Boards: UCC3817EVM
UCC3817EVM BiCMOS Power Factor Preregulator EVM
Lifecycle Status: Active (Recommended for new designs)
Anwendungshinweise
- PFC Pre-Regulator Frequency Dithering Circuit (Rev. A)PDF, 155 Kb, Revision: A, Datei veröffentlicht: May 14, 2010
PFC Pre-Regulator Frequency Dithering Circuit - PFC Family Differences UCC3817A/18A/19A and UCC3817/18/19PDF, 32 Kb, Datei veröffentlicht: Aug 18, 2003
The UCC3817A/18A/19A family of PFC controllers (UCC3817A family) is pin for pin compatible with the UCC3817/18/19 family of devices (UCC3817 family). The output stage of UCC3817A family has been updated to allow use of a smaller external gate drive resistor values. For some power supply designs where an adequately high enough gate drive resistor can not be used, the UCC3817A family offers a more r - UCC3817 Current Sense Transformer EvaluationPDF, 49 Kb, Datei veröffentlicht: Feb 13, 2004
- Synchronizing a PFC Controller from a Down Stream Controller Gate DrivePDF, 103 Kb, Datei veröffentlicht: Nov 3, 2000
Due to pending line harmonic requirements at higher power levels, power factor correction (PFC) is required in some ac-to-dc off-line power converter applications. This type of power converter can be designed with two cascaded power stages similar to the configuration in Figure 1. The first stage is a boost converter that converts the ac voltage to dc voltage with PFC. The output voltage of the bo - Bootstrap Circuit for Green Mode ApplicationsPDF, 111 Kb, Datei veröffentlicht: Jan 27, 2006
- Startup Current transient of the Leading Edge Triggered PFC ControllersPDF, 43 Kb, Datei veröffentlicht: Jun 30, 2004
- Avoiding Audible Noise at Light Loads When Using Leading Edge Triggered PFC Con (Rev. C)PDF, 57 Kb, Revision: C, Datei veröffentlicht: Apr 13, 2011
This application note applies to the TI average current mode, leading edge modulation PFC controllers. See Applicable Device Table for part numbers. - DN-66 UC3854A/B and UC3855A/B Provide Power Limiting with Sinusoidal Input (Rev. A)PDF, 80 Kb, Revision: A, Datei veröffentlicht: Nov 6, 2001
- Accurate PWM Duty Cycle ClampPDF, 58 Kb, Datei veröffentlicht: Jan 25, 2002
Power supply applications using current sense transformers require a duty cycle clamp on the pulse width modulator (PWM) to ensure transformer reset. Not all PWMs come with a duty cycle clamp presenting a problem for the power supply designer. This application note shows how to implement a duty cycle clamp by using a simple delay circuit.
Modellreihe
Serie: UCC2817A (8)
Herstellerklassifikation
- Semiconductors > Power Management > Offline and Isolated DC/DC Controllers and Converters > Power Factor Correction