Datasheet Texas Instruments UCC2817AD — Datenblatt

HerstellerTexas Instruments
SerieUCC2817A
ArtikelnummerUCC2817AD
Datasheet Texas Instruments UCC2817AD

BiCMOS Power Factor Preregualtor 16-SOIC -40 bis 85

Datenblätter

UCCx81xA BiCMOS Power Factor Preregulator datasheet
PDF, 1.1 Mb, Revision: D, Datei veröffentlicht: Aug 31, 2016
Auszug aus dem Dokument

Preise

Status

Lifecycle StatusActive (Recommended for new designs)
Manufacture's Sample AvailabilityYes

Verpackung

Pin16
Package TypeD
Industry STD TermSOIC
JEDEC CodeR-PDSO-G
Package QTY40
CarrierTUBE
Device MarkingUCC2817AD
Width (mm)3.91
Length (mm)9.9
Thickness (mm)1.58
Pitch (mm)1.27
Max Height (mm)1.75
Mechanical DataHerunterladen

Parameter

Control MethodCCM
Device TypeSingle-phase PFC
Operating Supply Current4 mA
Operating Supply(Max)18 V
Operating Temperature Range-40 to 85 C
Package GroupSOIC
Package Size: mm2:W x L16SOIC: 59 mm2: 6 x 9.9(SOIC) PKG
Peak Output Sink Current Gate Drive1.2 A
Peak Output Source Current Gate Drive-1.2 A
Practical Operating Frequency(Max)0.25 MHz
RatingCatalog
Special Features> 750W Applications,Average Current Mode,Enable,OVP
Startup Current0.15 mA
UVLO Thresholds On/Off16/10 V

Öko-Plan

RoHSCompliant

Design Kits und Evaluierungsmodule

  • Evaluation Modules & Boards: UCC3817EVM
    UCC3817EVM BiCMOS Power Factor Preregulator EVM
    Lifecycle Status: Active (Recommended for new designs)

Anwendungshinweise

  • PFC Pre-Regulator Frequency Dithering Circuit (Rev. A)
    PDF, 155 Kb, Revision: A, Datei veröffentlicht: May 14, 2010
    PFC Pre-Regulator Frequency Dithering Circuit
  • PFC Family Differences UCC3817A/18A/19A and UCC3817/18/19
    PDF, 32 Kb, Datei veröffentlicht: Aug 18, 2003
    The UCC3817A/18A/19A family of PFC controllers (UCC3817A family) is pin for pin compatible with the UCC3817/18/19 family of devices (UCC3817 family). The output stage of UCC3817A family has been updated to allow use of a smaller external gate drive resistor values. For some power supply designs where an adequately high enough gate drive resistor can not be used, the UCC3817A family offers a more r
  • UCC3817 Current Sense Transformer Evaluation
    PDF, 49 Kb, Datei veröffentlicht: Feb 13, 2004
  • Synchronizing a PFC Controller from a Down Stream Controller Gate Drive
    PDF, 103 Kb, Datei veröffentlicht: Nov 3, 2000
    Due to pending line harmonic requirements at higher power levels, power factor correction (PFC) is required in some ac-to-dc off-line power converter applications. This type of power converter can be designed with two cascaded power stages similar to the configuration in Figure 1. The first stage is a boost converter that converts the ac voltage to dc voltage with PFC. The output voltage of the bo
  • Bootstrap Circuit for Green Mode Applications
    PDF, 111 Kb, Datei veröffentlicht: Jan 27, 2006
  • Startup Current transient of the Leading Edge Triggered PFC Controllers
    PDF, 43 Kb, Datei veröffentlicht: Jun 30, 2004
  • Avoiding Audible Noise at Light Loads When Using Leading Edge Triggered PFC Con (Rev. C)
    PDF, 57 Kb, Revision: C, Datei veröffentlicht: Apr 13, 2011
    This application note applies to the TI average current mode, leading edge modulation PFC controllers. See Applicable Device Table for part numbers.
  • DN-66 UC3854A/B and UC3855A/B Provide Power Limiting with Sinusoidal Input (Rev. A)
    PDF, 80 Kb, Revision: A, Datei veröffentlicht: Nov 6, 2001
  • Accurate PWM Duty Cycle Clamp
    PDF, 58 Kb, Datei veröffentlicht: Jan 25, 2002
    Power supply applications using current sense transformers require a duty cycle clamp on the pulse width modulator (PWM) to ensure transformer reset. Not all PWMs come with a duty cycle clamp presenting a problem for the power supply designer. This application note shows how to implement a duty cycle clamp by using a simple delay circuit.

Modellreihe

Herstellerklassifikation

  • Semiconductors > Power Management > Offline and Isolated DC/DC Controllers and Converters > Power Factor Correction