Datasheet Texas Instruments LM329DZ/NOPB — Datenblatt

HerstellerTexas Instruments
SerieLM329
ArtikelnummerLM329DZ/NOPB
Datasheet Texas Instruments LM329DZ/NOPB

Präzisionsreferenz 3-TO-92 0 bis 70

Datenblätter

LM329 Precision Reference datasheet
PDF, 486 Kb, Revision: F, Datei veröffentlicht: Mar 29, 2013
Auszug aus dem Dokument

Preise

Parameter

Reference TypeShunt
Output TypeFixed
Voltage - Output (Min/Fixed)6.9 V
Current - Output15 mA
Package / Case
TO-92

Status

Lifecycle StatusNRND (Not recommended for new designs)
Manufacture's Sample AvailabilityNo

Verpackung

Pin33
Package TypeLPLP
Industry STD TermTO-92TO-92
JEDEC CodeO-PBCY-WO-PBCY-W
Package QTY18001800
Device MarkingLM329DZ
Width (mm)4.34.3
Length (mm)4.34.3
Thickness (mm)3.63.6
Pitch (mm)1.271.27
Max Height (mm)5.345.34
Mechanical DataHerunterladenHerunterladen

Öko-Plan

RoHSCompliant

Anwendungshinweise

  • AN-298 Isolation Techniques for Signal Conditioning (Rev. B)
    PDF, 685 Kb, Revision: B, Datei veröffentlicht: May 6, 2013
    This application note provides information and examples of isolation techniques for signal conditioning.
  • IC Temp Sensor Provides Thermocouple Cold-Junction Compensation (Rev. B)
    PDF, 271 Kb, Revision: B, Datei veröffentlicht: Apr 23, 2013
    Two circuits using the LM335 for thermocouple cold-junction compensation have been described. With asingle room temperature calibration, these circuits are accurate to В±3/4В°C over a 0В°C to 70В°C temperaturerange using J or K type thermocouples. In addition, a thermocouple amplifier using an LM335 for coldjunctioncompensation has been described for which worst case error can be as low as 1В°C p
  • AN-301 Signal Conditioning for Sophisticated Transducers (Rev. B)
    PDF, 1.2 Mb, Revision: B, Datei veröffentlicht: May 6, 2013
    This application note discusses signal conditioning and applications information for a diverse group ofsophisticated and unusual transducers.
  • AN-181 3-Terminal Regulator is Adjustable (Rev. B)
    PDF, 314 Kb, Revision: B, Datei veröffentlicht: May 5, 2013
    Until now all of the 3-terminal power IC voltage regulators have a fixed output voltage. In spite of this limitation their ease of use low cost and full on-chip overload protection have generated wide acceptance. Now with the introduction of the LM117 it is possible to use a single regulator for any output voltage from 1.2 V to 37 V at 1.5A. Selecting close-tolerance outp
  • AN-256 Circuitry for Inexpensive Relative Humidity Measurement (Rev. B)
    PDF, 262 Kb, Revision: B, Datei veröffentlicht: May 6, 2013
    Of all common environmental parameters humidity is perhaps the least understood and most difficult tomeasure. The most common electronic humidity detection methods albeit highly accurate are not obviousand tend to be expensive and complex (See Box). Accurate humidity measurement is vital to a number ofdiverse areas including food processing paper and lumber production pollution monitor
  • AN-263 Sine Wave Generation Techniques (Rev. C)
    PDF, 747 Kb, Revision: C, Datei veröffentlicht: Apr 22, 2013
    This application note describes the sine wave generation techniques to control frequency amplitude anddistortion levels.
  • TO-92 Packing Options / Ordering Instructions (Rev. A)
    PDF, 287 Kb, Revision: A, Datei veröffentlicht: Jun 23, 2010
  • Audio Applications of Linear Integrated Circuits
    PDF, 272 Kb, Datei veröffentlicht: May 2, 2004
  • AN-262 Applying Dual and Quad FET Op Amps (Rev. B)
    PDF, 1.1 Mb, Revision: B, Datei veröffentlicht: May 6, 2013
    The availability of dual and quad packaged FET op amps offers the designer all the traditional capabilitiesof FET op amps including low bias current and speed and some additional advantages. The cost-peramplifieris lower because of reduced package costs. This means that more amplifiers are available toimplement a function at a given cost making design easier. At the same time the availab
  • High Voltage Adjustable Power Supplies
    PDF, 87 Kb, Datei veröffentlicht: Oct 3, 2002
  • AN-284 Single-Supply Applications of CMOS MICRODACs (Rev. B)
    PDF, 271 Kb, Revision: B, Datei veröffentlicht: Apr 22, 2013
    CMOS data acquisition and conversion products are becoming the ideal choice for microprocessorcontrolled analog systems. The use of CMOS allows the addition of more digital logic functionality on tothe same die as the analog circuitry to minimize external parts requirements. The inherently low powerconsumption is also a big factor for battery operation and low heat generation in large scale

Modellreihe

Serie: LM329 (1)
  • LM329DZ/NOPB

Herstellerklassifikation

  • Semiconductors > Power Management > Voltage Reference > Shunt Voltage Reference