Datasheet Texas Instruments 74ALVCH16244ZRDR — Datenblatt

Hersteller	Texas Instruments
Serie	SN74ALVCH16244
Artikelnummer	74ALVCH16244ZRDR

Datenblätter

Preise

Status

Verpackung

Parameter

Öko-Plan

Anwendungshinweise

• Herunterladen
  Timing Differences of 10-pF Versus 50pF Loading
  PDF, 47 Kb, Datei veröffentlicht: Nov 1, 1996
  The 'ALVCH16244 is a 16-bit advanced low voltage CMOS (ALVC) unidirectional driver. Typically, data sheet values for tpd, ten, and tdis are characterized under a 50-pF capacitive load with a temperature range of -40?C to 85?C. At times these drivers are used in memory addressing for dual in-line memory modules (DIMM) with a 10-pF load and and temperature range of 0?C to 70?C. This document provide
• Herunterladen
  TI SN74ALVC16835 Component Specification Analysis for PC100
  PDF, 43 Kb, Datei veröffentlicht: Aug 3, 1998
  The PC100 standard establishes design parameters for the PC SDRAM DIMM that is designed to operate at 100 MHz. The 168-pin, 8-byte, registered SDRAM DIMM is a JEDEC-defined device (JC-42.5-96-146A). Some of the defined signal paths include data signals, address signals, and control signals. This application report discusses the SN74ALVC16835 18-bit universal bus driver that is available from T
• Herunterladen
  Logic Solutions for PC-100 SDRAM Registered DIMMs (Rev. A)
  PDF, 96 Kb, Revision: A, Datei veröffentlicht: May 13, 1998
  Design of high-performance personal computer (PC) systems that are capable of meeting the needs imposed by modern operating systems and software includes the use of large banks of SDRAMs on DIMMs (see Figure 1).To meet the demands of stable functionality over the broad spectrum of operating environments, meet system timing needs, and to support data integrity, the loads presented by the large
• Herunterladen
  Bus-Hold Circuit
  PDF, 418 Kb, Datei veröffentlicht: Feb 5, 2001
  When designing systems that include CMOS devices, designers must pay special attention to the operating condition in which all of the bus drivers are in an inactive, high-impedance condition (3-state). Unless special measures are taken, this condition can lead to undefined levels and, thus, to a significant increase in the device?s power dissipation. In extreme cases, this leads to oscillation of
• Herunterladen
  16-Bit Widebus Logic Families in 56-Ball 0.65-mm Pitch Very Thin Fine-Pitch BGA (Rev. B)
  PDF, 895 Kb, Revision: B, Datei veröffentlicht: May 22, 2002
  TI?s 56-ball MicroStar Jr.E package registered under JEDEC MO-225 has demonstrated through modeling and experimentation that it is an optimal solution for reducing inductance and capacitance improving thermal performance and minimizing board area usage in integrated bus functions. Multiple functions released in the 56-ball MicroStar Jr.E package have superior performance characteristics compa
• Herunterladen
  Bus-Interface Devices With Output-Damping Resistors Or Reduced-Drive Outputs (Rev. A)
  PDF, 105 Kb, Revision: A, Datei veröffentlicht: Aug 1, 1997
  The spectrum of bus-interface devices with damping resistors or balanced/light output drive currently offered by various logic vendors is confusing at best. Inconsistencies in naming conventions and methods used for implementation make it difficult to identify the best solution for a given application. This report attempts to clarify the issue by looking at several vendors? approaches and discussi
• Herunterladen
  Benefits & Issues of Migrating 5-V and 3.3-V Logic to Lower-Voltage Supplies (Rev. A)
  PDF, 154 Kb, Revision: A, Datei veröffentlicht: Sep 8, 1999
  In the last few years the trend toward reducing supply voltage (VCC) has continued as reflected in an additional specification of 2.5-V VCC for the AVC ALVT ALVC LVC LV and the CBTLV families.In this application report the different logic levels at VCC of 5 V 3.3 V 2.5 V and 1.8 V are compared. Within the report the possibilities for migration from 5-V logic and 3.3-V logic families
• Herunterladen
  Understanding Advanced Bus-Interface Products Design Guide
  PDF, 253 Kb, Datei veröffentlicht: May 1, 1996
• Herunterladen
  Migration From 3.3-V To 2.5-V Power Supplies For Logic Devices
  PDF, 115 Kb, Datei veröffentlicht: Dec 1, 1997
  This application report explores the possibilities for migrating to 3.3-V and 2.5-V power supplies and discusses the implications.Customers are successfully using a wide range of low-voltage 3.3-V logic devices. These devices are within Texas Instruments (TI) advanced low-voltage CMOS (ALVC) crossbar technology (CBT) crossbar technology with integrated diode (CBTD) low-voltage crossbar techn
• Herunterladen
  TI IBIS File Creation Validation and Distribution Processes
  PDF, 380 Kb, Datei veröffentlicht: Aug 29, 2002
  The Input/Output Buffer Information Specification (IBIS) also known as ANSI/EIA-656 has become widely accepted among electronic design automation (EDA) vendors semiconductor vendors and system designers as the format for digital electrical interface data. Because IBIS models do not reveal proprietary internal processes or architectural information semiconductor vendors? support for IBIS con
• Herunterladen
  Live Insertion
  PDF, 150 Kb, Datei veröffentlicht: Oct 1, 1996
  Many applications require the ability to exchange modules in electronic systems without removing the supply voltage from the module (live insertion). For example an electronic telephone exchange must always remain operational even during module maintenance and repair. To avoid damaging components additional circuitry modifications are necessary. This document describes in detail the phenomena tha
• Herunterladen
  CMOS Power Consumption and CPD Calculation (Rev. B)
  PDF, 89 Kb, Revision: B, Datei veröffentlicht: Jun 1, 1997
  Reduction of power consumption makes a device more reliable. The need for devices that consume a minimum amount of power was a major driving force behind the development of CMOS technologies. As a result CMOS devices are best known for low power consumption. However for minimizing the power requirements of a board or a system simply knowing that CMOS devices may use less power than equivale
• Herunterladen
  Input and Output Characteristics of Digital Integrated Circuits
  PDF, 1.7 Mb, Datei veröffentlicht: Oct 1, 1996
  This report contains a comprehensive collection of the input and output characteristic curves of typical integrated circuits from various logic families. These curves go beyond the information given in data sheets by providing additional details regarding the characteristics of the components. This knowledge is particularly useful when for example a decision must be made as to which circuit shou

Modellreihe

Herstellerklassifikation

• Semiconductors > Logic > Buffer/Driver/Transceiver > Non-Inverting Buffer/Driver